2-piece

As a trade printing expert, we take each binding process very seriously, so that your clients’ demands go beyond their expectations. Here’s an general overview of the 2-piece binding production process: Text Block Preparation: The first step is to prepare the text block, which is the body of the book. This involves printing the book's content on sheets of paper, then folding and cutting these sheets into pages. The pages are then gathered into signatures (small groups of pages), which are sewn or glued together at the spine. Spine Reinforcement: The spine of the text block may be reinforced with a cloth strip or other material to provide additional strength and support. Cover Creation: The cover for a 2-piece binding book is made from two different materials. The material for the spine (often a stronger or more decorative material like cloth or leather) is cut to the appropriate size. The material for the front and back covers (commonly a type of board covered with paper, cloth, or another material) is also cut to size. These pieces are then joined together, leaving a small gap between the spine and the cover boards to allow the book to open and close easily. Attaching the Text Block to the Cover: The text block is then attached to the cover. This is usually done by applying adhesive to the spine of the text block and then positioning it against the spine of the cover. The endpapers (blank or decorative sheets at the front and back of the book) are often used to further secure the text block to the cover. Finishing Touches: Additional elements such as headbands (decorative elements at the top and bottom of the spine), a bookmark ribbon, or cover decorations (like embossing, foil stamping, or printing) are added. The book is then trimmed to its final size if necessary. Quality Check and Completion: Finally, the book undergoes a quality check to ensure that the binding is secure and the book opens and closes properly. Any necessary corrections are made before the book is deemed finished.